First turn on the adjustment mode: (1) The material tray moves from the front
chamber to the back chamber. Press the forward button F3 of the push device
until the signal light 1 of the material hook hooked to the material tray lights
up. Carburizing
process and carburized steel Then press the back button F4 of the push-pull
device to pull out the material tray. ,until the material tray reaches the
pulling position, the material hook is decoupled [decoupling light 2 lights up]
Press F5 to open the middle door, Vacuum
tempering process of steel press F3 to push the material tray into the rear
chamber, 4 lights up after being pushed into place, the material hook returns to
5, and the middle door When closed, the material hook returns to its original
position and the action stops.Powder
metallurgy stainless steel vacuum sintering process (2) To move the material
tray from the back room to the front room, first raise the lifting platform,
press the F3 material hook to 11, open the middle door, stop the material hook
to 4, and then press F3 to move the material hook to the 13 pan grabbing
position. Press F4, move the material hook to 14, close the middle furnace door,
lower the lifting platform to the oil tank, and return the material hook to its
original position.What Sets Vacuum Brazing Apart from the Rest